Massa M3 Manual de usuario descargar pdf (Pagina 15)

Instruction Guide – Massa M3 Wireless Sensor Evaluation Kit Page of 14

M3 Kit Guide 111017.docx 10-20-2011

PRELIMINARY

APPENDIX D

Digi Device Discovery Application

To gain access to the X4 Gateway you will need to get an Ethernet connection to the Gateway and

then use the Device Discovery Software. The X4 Gateway’s Ethernet IP Settings are configured to

obtain an IP address automatically using DHCP. Contact your network administrator if you need

support for this. Another option is to plug the Gateway directly into your PC Ethernet port with your

PC’s Local Area Connection TCP/IP set to obtain an IP address automatically. Run the Device

Discovery to find the gateway as you see in the screen below. Double click the IP address found to

get to the Digi Web pages (bottom figure below).

Should it be necessary to change a Gateway setting, you will have to proceed in gaining access as

shown here. The kit for one system will not need any changes for use with the M3 Software.

However, an example that will require a settings change is where 2 Gateways are present in the same

area. This will require the PAN IDs of both the Sensors and 2

Gateway to be changed to a number

other than the default value of 1 assigned to the Massa M3 Evaluation Kit.

1 2 ... 10 11 12 13 14 15

Sin comentarios

Massa M3 Manual de usuario Pagina 15