Massa M3 Manual de usuario descargar pdf (Pagina 26)

MASSA PRODUCTS CORPORATION June 11, 2013

Product Manual 25 M3 Wireless Ultrasonic Level Sensor

13.10 Programming Tab - XBee OTA Firmare Programming (from previous page)

Prepare this page for XBee FW uploading BUT DON’T

CLICK THE “Update” BUTTON JUST YET.

Check the sensor Node, here ending in da61. Next, select

the firmware to upload under the “Update selected nodes

with firmware file” menu (see here ending in 29A0). Select

the gateway under the “Use this router node as the updater”.

AGAIN, DON’T CLICK UPDATE.

Now go to the M3 Software application “Program Sensor

Firmware” tab and click on the “Keep Radio Awake 2 min”

button. Wait for the acknowledge message to the right of

the button.

Note: When this feature has been activated, the sensor’s

LED will blink fast continuously.

Now as soon as possible, click on the Update button on the

“OTA Firmware Update Status” page. The Status will

indicate “Updating”.

Note: You will notice the sensor’s LED turn off. It will turn

back on when the XBee firmware upload is complete.

When the firmware upload has completed (approximately 1

minute in which the sensor’s LED starts blinking), click the

Refresh button. The Status indication will report

“Complete” and the FW will display the new firmware.

Note: The sensor LED will stop blinking fast after the 2

minute time has expired from the Keep Radio Awake 2 Min

button press and will follow to the normal 2 second blink.

1 2 ... 21 22 23 24 25 26 27 28 29

Sin comentarios

Massa M3 Manual de usuario Pagina 26